How to Remove and Replace the Exterior Handle on a Hyundai Tucson 2004-2009
How to Remove and Replace the Exterior Handle on a Hyundai Tucson 2004-2009
In this video we demonstrate the most effective way to remove and replace a Hyundai Tucson Exterior Handle suited for the year models 2004-2009. These handles tend to snap at both of the main points causing the handle to fall out.
This product is available at: https://partsfactoryaus.com.au/product/hyundai-tucson-exterior-door-handle/
Like and Follow us on Instagram for more tutorials!! 🙂 @Partsfactoryaus
Mate your as true blue as Bundy rum thanks for the video.
Thank you so much for a precise instruction and demonstration. You turned it into an easy 20 minute job.
Thank you for this video. This helps for me to work on the REAR RIGHT side door handle.
I have to curse again on Hyundai’s stupid design. The outside handle is 100 plastic and broke. And the replacing job should be not difficult but it is. I once replaced the motor gasket and it’s so damn difficult to open it due to its dimension. For the rear door handle, it’s more difficult than the one on front. At 10:53 you can see there is a hole that allows you to insert screw driver to work on the bolt that attaches the handle to the door. On the rear door, there is no such thing. The bolt spot area is completely covered by metal penal. The bolt is INVISIBLE and UNREACHABLE and the space is too tight for a hand of most people. And the sharp metal edge near that space cut my hand while I was trying to feel and work the bolt. I barely was able to take it off and put a replacement on it. But it does not work. Had to work again. I could not find one video on the REAR RIGHT door.
How about the rear handle. Because its not the same
I just did the rear handle. It would be nice to have a video of it, but I’ll post here in case anyone else needs to do it. The process is pretty much the same apart from the lock barrel, the difference is that the rear bolt on the inner assembly (the white/yellow part) is really hard to get to. I had to use a simple 10mm wrench and feel for it with my hand. I couldn’t fit my socket wrench in there, but it would be a lot easier with a ratcheting wrench. I undid the bolt far enough that I could pull the whole inner assembly out. That allowed me to line up the outer handle. Then you have to push the inner assembly tight against the inside of the door and slide it forward with the outer handle all the way in to get the mechanical catch lined up with the outer handle. Once the pieces are in place the bolts can be tightened back up.
Thanks mate
Love the intro 👌 especially “jetv6”
thank you so much for the video. I have to install a handle in a few days on my tucson from 2005
Cambio de manecilla externa
Tried looking on ur site for the part but can’t find it
Hi, do you also have a tutorial to replace the plastic door trim in the front?
difficult on the inside but nice vlog thanks
Do the rear door handle
How about the rear right handle? Very difficult to remove the old one coz of the child lock obstructing the 2nd bolt/screw… thanks for very informative video..
Thx a lot. Its my turn now, left side.
Wish me luck 😊😊😊
Thank you ! Now it will Be easy form me! 👏👏👏
🙌🏼🙌🏼
Absolute legend.
Going to give it a crack tomorrow.